Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hyundai Elantra L4-2.0LFACTORY OEM SERVICE PROCEDURE
Rear Wheel Alignment
REAR WHEEL ALIGNMENT
TOE-IN
Standard value: 4 +3/-1 mm (0.16 +0.12/-0.04 inch)
NOTE:
^ Adjust the toe-in by turning the tie rod end of the rear suspension arm.
Left tie rod: Clockwise direction : ton-in
Right tie rod: Clockwise direction : toe-out
A variation of toe by a rotation of the tie rod
About 6 mm (0.60)
^ The cam bolt should be adjusted to a maximum of 90° left or right from the center position.

CAUTION: After adjusting the tie rod, tighten both nuts to the specified torque.
Specified torque 50 - 60 Nm (500 - 600 kg-cm, 37 - 43 ft. lbs.)
TOE-IN
Standard value: 4 +3/-1 mm (0.16 +0.12/-0.04 inch)
NOTE:
^ Adjust the toe-in by turning the tie rod end of the rear suspension arm.
Left tie rod: Clockwise direction : ton-in
Right tie rod: Clockwise direction : toe-out
A variation of toe by a rotation of the tie rod
About 6 mm (0.60)
^ The cam bolt should be adjusted to a maximum of 90° left or right from the center position.
CAUTION: After adjusting the tie rod, tighten both nuts to the specified torque.
Specified torque 50 - 60 Nm (500 - 600 kg-cm, 37 - 43 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
