Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003ACCENT L4-1.6LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSCOOLING SYSTEMSYSTEM SPECIFICATIONS
2003 Hyundai Accent L4-1.6L
System Specifications
2003 Hyundai Accent L4-1.6LSECTION System Specifications
Cooling Method; Water-cooled, pressurized, Forced circulation with electrical fan
Radiator Type Pressurized Corrugated Fin Type
COOLANT PUMP
Coolant Pump Type Centrifugal Type Impeller
Coolant pump pulley 8-10 Nm (80 - 100 kg-cm, 6 - 7 ft. lbs.)
Coolant pump bolt 12-15 Nm (120-150 kg-cm, 9-11 ft. lbs.)
THERMOSTAT
Type Wax pellet type with jiggle valve
Thermostat housing bolt 15-20 Nm (150-200 kg-cm, 11-15 ft. lbs.)
ENGINE COOLANT HOSE/PIPES
Coolant inlet fitting bolt......17 - 20 Nm (170 - 200 kg-cm, 13 - 14 ft. lbs.)
Radiator Type Pressurized Corrugated Fin Type
COOLANT PUMP
ENGINE COOLANT PUMP:
Coolant Pump Type Centrifugal Type Impeller
Coolant pump pulley 8-10 Nm (80 - 100 kg-cm, 6 - 7 ft. lbs.)
Coolant pump bolt 12-15 Nm (120-150 kg-cm, 9-11 ft. lbs.)
THERMOSTAT
THERMOSTAT:
Type Wax pellet type with jiggle valve
Thermostat housing bolt 15-20 Nm (150-200 kg-cm, 11-15 ft. lbs.)
ENGINE COOLANT HOSE/PIPES
Coolant inlet fitting bolt......17 - 20 Nm (170 - 200 kg-cm, 13 - 14 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.