Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hyundai Accent BaseFACTORY OEM SERVICE PROCEDURE
Steering System: General: Specifications
General Specifications
| Item | Specification |
|---|---|
| Manual steering | |
| Shaft and joint type | Collapsible, cross joints (two joints used) |
| Steering gear type | Rack and pinion |
| Rack stroke | 134 mm (lock to lock : 3.87 turns) |
| Power steering | |
| Shaft and joint type | Collapsible, cross joints, tilt column with pop-up |
| Steering gear type | Rack and pinion |
| Rack stroke | 134 mm (lock to lock : 2.93 turns) |
| Oil pump type | Vane type |
| Oil pump displacement | 9.6 cm3 /rev. (0.59 in3 /rev.) |
| Oil pump pressure switch operating pressure | 1.5-2.0 MPa (15-20 kg/cm2 , 213-284 psi) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.