SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2002XG350 BASEREPAIR AND DIAGNOSISENGINE PERFORMANCESPECIFICATIONSENGINE CONTROLS - SERVICE & ADJUSTMENT SPECIFICATIONSQUICK-SERVICESERVICE INTERVALS & SPECIFICATIONS
2002 Hyundai XG350 Base

Service Intervals & Specifications

2002 Hyundai XG350 BaseSECTION Service Intervals & Specifications
REPLACEMENT INTERVALS (1)

Component Months Miles
Accessory Drive Belts
Normal & Severe Service 24 (2)(3)(4) (2) 30,000
Air Filter
Normal & Severe Service 24 30,000
Automatic Transmission Fluid & Filter
Normal Service 84 (5) (5) 105,000
Severe Service (5) (5) 30,000
Brake Fluid
Normal & Severe Service 24 (2) (2) 30,000
Coolant
Normal & Severe Service 24 30,000
Engine Oil & Filter
Normal Service 6 7500
Severe Service 3 3000
Fuel Filter
Normal & Severe Service 42 (1) (1) 52,500
Manual Transmission Fluid
Normal & Severe Service 24 (2) (2) 30,000
PCV Valve
Normal & Severe Service 42 (2) (2) 52,500
Spark Plugs (Platinum)
Normal & Severe Service 48 (1) (1) 60,000
Spark Plugs (Non-Platinum)
Normal & Severe Service 24 (1) (1) 30,000
Timing Belt
Normal & Severe Service 24 (6) (6) 30,000
(1) A more frequent interval is required for severe service. Severe service is described as trailer towing, off-highway operation, snow removal operation, or operating in dusty or excessively hot conditions.
(2) Inspect at scheduled interval and replace as necessary.
(3) On Santa Fe 2.4L inspect every 24 months or 30,000 miles and replace if necessary. Replace every 48 months or 60,000 miles if not previously replaced.
(4) On Santa Fe 2.7L and XG350 3.5L inspect every oil and filter change and replace if necessary. Replace every 60 months or 75,000 miles if not previously replaced.
(5) Inspect fluid level and condition every engine oil and filter change. Top-off or replace as necessary or at specified interval.
(6) Inspect at specified interval and replace every 48 months or 60,000 miles. For California, replacement is recommended, but not required.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.