2002 Hyundai XG350 BaseFACTORY OEM SERVICE PROCEDURE

Shift Lock And Key Lock Cable

  1. Check that each lock cam is as shown. See Fig 1 .
  2. Install the shift lock and key lock cable in position. In this case, the shift lock cable must be fixed to the brake pedal and the key lock cable must be fixed to the key cylinder.
  3. Temporarily install each cable to the A/T lever assembly as shown. See Fig 1 . Securely insert the cable end into the fixing pin of each cam.
  4. Slightly pull the shift lock cable in the direction "E".
  5. After checking that the portion of the cable end touches the cable fixing pin, fix with the self-tapping bolt.
  6. Slightly push the key lock cam to direction "Q".
  7. Slightly pull the key lock cable in the direction "G" to stretch the cable. Then fix the cable with the self-tapping bolt.
  8. Check that the key lock and the shift lock cable are secure.
Fig 1: Adjusting Shift Lock & Key Lock Cable
G00356289Courtesy of HYUNDAI MOTOR CO.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.