SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2002XG350 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE SYSTEMAUTOMATIC TRANSAXLEINSTALLATION
2002 Hyundai XG350 Base

Automatic Transaxle: Installation

2002 Hyundai XG350 BaseSECTION Installation
  1. Attach the torque converter on the transaxle side and mount the transaxle assembly onto the engine.
    CAUTION: If the torque converter is mounted first on the engine, the oil seal on the transaxle may be damaged. Therefore, first be sure to assemble the torque converter to the transaxle.
  2. Install the transaxle control cable and adjust as follows:
    1. Move the shift lever and the transaxle range switch to the "N" position and install the control cable.
    2. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts to the control cable.
    3. Remove any free-play in the control cable by adjusting the nut and then check to see that the selected lever moves smoothly.
    4. Check to see that the control cable has been adjusted correctly.
  3. Installation is the reverse of removal.
    Fig 1: Installing Control Cable
    G00722189Courtesy of HYUNDAI MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.