Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
To Set Memorized Driving Position Using IMS Control Switch
2002 Hyundai XG350 BaseSECTION To Set Memorized Driving Position Using IMS Control Switch
NOTE:
Signal beeps indicate that driver's seat and mirror positions have been memorized and are stored in the IMS memory module.
- Turn ignition switch to ON position. Using manual control switches, adjust the driver's seat and outside mirrors to desired positions.
- Press and hold the "M" button on IMS control switch until a signal beep is heard one time. Within 5 seconds, press and hold the "1" or "2" button until signal beeps 2 times.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.