SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2002SANTA FE BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICS - 2.4LSELF-DIAGNOSTIC SYSTEMPOWERTRAIN CONTROL MODULE & ENGINE CONTROL MODULE, LOCATION & CONNECTOR IDENTIFICATION
2002 Hyundai Santa Fe Base, Automatic

Powertrain Control Module & Engine Control Module, Location & Connector Identification

2002 Hyundai Santa Fe Base, AutomaticSECTION Powertrain Control Module & Engine Control Module, Location & Connector Identification
NOTE: Engine Control Module (ECM), can also be referred to as Powertrain Control Module (PCM).

Powertrain Control Module (PCM) and Engine Control Module (ECM) are located below center of instrument panel, near floor. To identifying component connectors terminals. See Fig 1 and Fig 2 .

Fig 1: Identifying Powertrain Control Module Connectors Terminals (2.4L - A/T)
G00140028Courtesy of HYUNDAI MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.