2002 Hyundai Accent LFACTORY OEM SERVICE PROCEDURE

Field Coil Test

  1. Check field coil continuity by connecting ohmmeter probes to field coil positive terminal and brush holder. See Fig 1 Replace field coil if continuity does not exist (open circuit).
  2. Check for grounded field coil by placing one ohmmeter probe on starter housing and other probe on field coil positive terminal. See Fig 2 If continuity is present, field coil is grounded and must be replaced.
Fig 1: Checking Field Coil Continuity
G00195410Courtesy of HYUNDAI MOTOR CO.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.