Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Tightening Torque Specifications
TIGHTENING TORQUE

1 of 2

2 of 2
Front Case (Oil Pump)
Case to Engine Block 12 - 15 Nm (120 - 150 kg.cm, 9 - 11 lb. ft)
Sequences
Cylinder Head

Removal

Installation
Note: Do not reuse cylinder head bolts over 2 - 3 times.
Camshaft Bearing Caps

Installation
Main Bearing Cap Installation
Center, No.2, No.4 front and rear caps
1 of 2
2 of 2
Front Case (Oil Pump)
Case to Engine Block 12 - 15 Nm (120 - 150 kg.cm, 9 - 11 lb. ft)
Sequences
Cylinder Head
Removal
Installation
Note: Do not reuse cylinder head bolts over 2 - 3 times.
Camshaft Bearing Caps
Installation
Main Bearing Cap Installation
Center, No.2, No.4 front and rear caps
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
