Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Connecting Rod Service Specifications
| Connecting Rod | Cap Nut | 50 - 53 Newton Meter (Nm) |
| Bend | 0.05 Millimeter (mm) Or Less | |
| Twist | 0.1 Millimeter (mm) Or Less | |
| Connecting Rod Big End To Crankshaft Side Clearance | 0.1 - 0.25 Millimeter (mm) | |
| Limit | 0.4 Millimeter (mm) | |
| Oil Clearance | 0.024 - 0.044 Millimeter (mm) | |
| Limit | 0.1 Millimeter (mm) | |
| Undersize | 0.25, 0.50, 0.75 Millimeter (mm) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
