Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Knock Sensor: Testing and Inspection
CIRCUIT DESCRIPTION
The knock sensor is attached to the cylinder block and senses engine knocking conditions. A knocking vibration from the cylinder block is applied as pressure to the piezoelectric element. This vibrational pressure is then converted into a voltage signal which is delivered as output. If engine knocking occurs, ignition timing is retarded to suppress it.
Circuit Diagram:
Troubleshooting Procedures:
TROUBLESHOOTING HINTS
1. The MIL is ON or the DTC is displayed on the HI-SCAN under the following condition;
- When the knock sensor signal is not detected though the engine is in the over load condition.
2. When knock sensor signal is abnormally low.
Harness Inspection Procedures:
SENSOR INSPECTION
1. Disconnect the knock sensor connector.
2. Measure resistance between the terminal 1 and 2.
Standard value : about 5 Mohm [at 20 °C (68 °F)]
3. If the resistance is continuous, replace the knock sensor.
Knock sensor : 16 - 28 Nm (160 - 250 kg.cm, 11.8 - 18.4 lb.ft)
4. Measure the capacitance between the terminal 1 & 2.
Standard value : 800 - 1600 pF
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
