2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Service and Repair

Factory service manual diagram





REMOVAL
1. Drain the coolant down to sensor level or below.
2. Disconnect the battery 9 round cable and disconnect the engine harness connector from the sender & sensor.
3. Remove the sender & sensor.

INSPECTION
Coolant Temperature Sender

Factory service manual diagram




1. Heat the engine coolant temperature sender by submerging it in hot water.
2. Check that the resistance is within the specified range.
Resistance
90.5 - 117.5 ohms at 70°C (158°F)
21.3 - 26.3 ohms at 115°C (239°F)

Coolant Temperature Sensor

Factory service manual diagram




1. Heat the sensor by submerging it in hot water.
2. Check that the resistance is within the specified range.
Resistance
2.27 - 2.73 K ohms at 20°C (68°F)
290 - 354 ohms at 80°C (176°F)

INSTALLATION

Factory service manual diagram




1. Apply sealant to the threaded portion and tighten to the specified torque.
Tightening torque
Coolant temperature sender 10 - 12 Nm (100 - 120 kg.cm, 7 - 9 ft. lbs.)
Coolant temperature sensor 15 - 20 Nm (150 - 200 kg.cm, 11 - 15 ft. lbs.)
2. Connect the harness connector to the coolant temperature sender, coolant temperature sensor.
3. Connect the battery ground cable.
4. Refill the system with clean coolant.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.