2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Timer/Control Unit: Service and Repair

ELECTRONIC TIME AND ALARM CONTROL MODULE

Factory service manual diagram



1. Disconnect the negative battery terminal.
2. Remove the shift lever boot using a (-) driver.

Factory service manual diagram



3. Remove the center facia panel.

Factory service manual diagram



4. After removal of the ETACM (Electronic Time and Alarm Control Module) mounting bolts (2EA), disconnect its connector.
5. Installation is the reverse of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.