Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Alignment: Specifications
Alignment Specifications revised per TSB # 02-50-005
Tire Pressure PSI Front/Rear 30/30
Total Toe (Cross):
Front 0 ± 3 mm (N/A)
Rear 4 + 3 mm - 1 mm (N/A)
Camber (Cross):
Front - 0.17° ± 0.5° * (0.5°)
Rear - 0.9° ± 0.5° * (0.5°)
Caster (Cross):
Front 2.45° ± 0.5° * (0.5°)
King Pin Inclination Angle 12°43' ± 30'
King Pin Offset - 1.2 mm
* = Angle is not adjustable
Tire Pressure PSI Front/Rear 30/30
Total Toe (Cross):
Front 0 ± 3 mm (N/A)
Rear 4 + 3 mm - 1 mm (N/A)
Camber (Cross):
Front - 0.17° ± 0.5° * (0.5°)
Rear - 0.9° ± 0.5° * (0.5°)
Caster (Cross):
Front 2.45° ± 0.5° * (0.5°)
King Pin Inclination Angle 12°43' ± 30'
King Pin Offset - 1.2 mm
* = Angle is not adjustable
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
