2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Rear Wheel Alignment

REAR WHEEL ALIGNMENT INSPECTION
Toe-in
Standard value: 4 +3/-1 mm (0.16 +0.12/-0.04 inch)

Factory service manual diagram




NOTE: The rear suspension (T) mounting bolt should be turned an equal amount on both sides when adjusting. Loosen the rearside nut prior to adjusting the eccentric bolt.

Left wheel: Clockwise direction: toe-in
Right wheel: Clockwise direction: toe-out
The scale has gradations of approximately 2.4 mm (0.09 inch) (Single side toe angle equivalent to 14')

Factory service manual diagram




CAUTION: The eccentric bolt should be adjusted within a 90° range left and right from the center position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.