Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Service and Repair
HEATER CONTROL PANEL ASSEMBLY

REMOVAL

1. Remove the shift lever upper cover.

2. Remove the facia panel mounting screws.

3. Remove the floor console mounting screws (4EA) and then, remove the floor console.

4. Disconnect the rheostat switch.

5. Remove the lower crash pad panel.

6. Remove the cluster facia panel mounting screws (5EA) from the cluster facia panel.

7. Pull out the cluster facia panel, disconnect switch extension wire connector, vacuum harness connector, blowers switch connector, A/C switch connector.

8. Remove the heater control panel mounting screws.

9. Remove the heater control panel assembly from the cluster facia panel.
INSTALLATION
Installation is the reverse order of removal.
REMOVAL
1. Remove the shift lever upper cover.
2. Remove the facia panel mounting screws.
3. Remove the floor console mounting screws (4EA) and then, remove the floor console.
4. Disconnect the rheostat switch.
5. Remove the lower crash pad panel.
6. Remove the cluster facia panel mounting screws (5EA) from the cluster facia panel.
7. Pull out the cluster facia panel, disconnect switch extension wire connector, vacuum harness connector, blowers switch connector, A/C switch connector.
8. Remove the heater control panel mounting screws.
9. Remove the heater control panel assembly from the cluster facia panel.
INSTALLATION
Installation is the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
