Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Tiburon AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System Troubleshooting
- Troubleshooting (A/T)
- General
- Troubleshooting Flow Chart
- Road Test
- Inspection Chart For Diagnostic Trouble Codes
- Diagnostic Trouble Code Identification
- Inspection Procedures For Diagnostic Trouble Codes
- DTC P1703: Throttle Position Sensor
- DTC P0712 & P0713: Fluid Temperature Sensor System (Open/Shorted)
- DTC P1709: Kick Down Servo Switch (Open/Shorted)
- DTC P0727: Engine Speed Signal
- DTC P0717: Pulse Generator A (Open)
- DTC P0722: Pulse Generator B (Open)
- DTC P0750: Shift Control Solenoid Valve A (Shorted/Open)
- DTC P0755: Shift Control Solenoid Valve B (Open/Shorted)
- DTC P0760: Shift Control Solenoid Valve C (Open/Shorted)
- DTC P0745: Pressure Control Solenoid Valve A (Open/Shorted)
- DTC P0765: Pressure Control Solenoid Valve B (Open/Shorted)
- DTC P0743 & P0740: Damper Clutch Control Solenoid Valve (Open/Shorted), Damper Clutch System (Stuck On)
- DTC P0731: First Gear System Malfunction
- DTC P0732: Second Gear System Malfunction
- DTC P0733: Third Gear System Malfunction
- DTC P0734: Fourth Gear Malfunction
- Inspection Chart For Trouble
- Inspection Procedure 1
- Inspection Procedure 2
- Inspection Procedure 3
- Inspection Procedure 4
- Inspection Procedure 5
- Inspection Procedure 6
- Inspection Procedure 7
- Inspection Procedure 8
- Inspection Procedure 9
- Inspection Procedure 10
- Inspection Procedure 11
- Inspection Procedure 12
- Inspection Procedure 13
- Inspection Procedure 14
- Inspection Procedure 15
- Obtaining Diagnostic Trouble Codes
- Malfunction Indicator Light (Mil)
- Checking The Control System (When A GI-Scan Is Used)
- Element In Use At Each Position Of Selector Lever
- Inspection Of Electronic Control System Components
- Oil Pressure Tests
- Preliminary Steps If Oil Pressure Is Not Normal
- Automatic Transaxle Shift Control
- Shift Lever
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.