Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Sonata Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle Shift Control: Installation
- Apply a coating of the specified grease to the interior of the adjust bushing.
Specified grease - Chassis grease SAE J310, NLGI No.0
- Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.
- When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in the position shown in the illustration.
- When connecting the control cable to the shift lever mounting bracket, install the clip until it contacts the control cable.
- Install the control cable, the key lock cable and the shift cable mounting bolt.
- Install the indicator and the bulb connector.
- Install the selector knob.
- Install the shift lever assembly.
- Install the nut and washer.
- Install the console cover plate and upper cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.