2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE

Engine Torque Strut

Engine Torque Strut Front Roll Stopper Bracket To Cross Member Bolts 40 - 55 Newton Meter (Nm)
Front Roll Stopper Insulator Bolt And Nut 50 - 65 Newton Meter (Nm)
Transaxle Mounting Bracket Bolts 60 - 80 Newton Meter (Nm)
Rear Roll Stopper Bracket To Cross Member Bolts 50 - 65 Newton Meter (Nm)
Rear Roll Stopper Insulator Bolt And Nut 50 - 65 Newton Meter (Nm)
Transaxle Mounting Insulator Bolt 90 - 110 Newton Meter (Nm)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.