Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE
Oscilloscope Patterns and Waveforms
MAJOR SENSOR REFERENCE WAVE-FORMS
The followings are the major sensor reference wave-forms. Below is the data for CMP, Mass Air Flow Sensor, Throttle Position Sensor, Rear O(2) Sensor, Front O(2) Sensor and Injection Pulse when revving quickly up to 4800 rpm under no load after warming up engine sufficiently. Each value is for reference, the exact values may vary.


* CMP and CKP
Should increase gradually while depressing the accelerator pedal and should decrease gradually after releasing the pedal without any intermittent drop or rise.


* MAF sensor and TPS
MAF should increase when depressing the accelerator pedal and should decrease at the moment "THRTL POS SEN" is closed (accelerator pedal is released).
TPS should increase while depressing the accelerator pedal and should decrease while releasing it.

* FR O(2) SENSOR and RR O(2) SENSOR
FR O(2) and RR O(2) sensor may increase immediately after depressing the accelerator pedal and may decrease after releasing the pedal.

* INJ PULSE
Should increase when depressing the accelerator pedal and should decrease when the pedal is released.
The followings are the major sensor reference wave-forms. Below is the data for CMP, Mass Air Flow Sensor, Throttle Position Sensor, Rear O(2) Sensor, Front O(2) Sensor and Injection Pulse when revving quickly up to 4800 rpm under no load after warming up engine sufficiently. Each value is for reference, the exact values may vary.
* CMP and CKP
Should increase gradually while depressing the accelerator pedal and should decrease gradually after releasing the pedal without any intermittent drop or rise.
* MAF sensor and TPS
MAF should increase when depressing the accelerator pedal and should decrease at the moment "THRTL POS SEN" is closed (accelerator pedal is released).
TPS should increase while depressing the accelerator pedal and should decrease while releasing it.
* FR O(2) SENSOR and RR O(2) SENSOR
FR O(2) and RR O(2) sensor may increase immediately after depressing the accelerator pedal and may decrease after releasing the pedal.
* INJ PULSE
Should increase when depressing the accelerator pedal and should decrease when the pedal is released.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
