2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection

Factory service manual diagram



ENGINE COOLANT TEMPERATURE (ECT) SENSOR
The engine coolant temperature sensor installed in the engine coolant passage of the cylinder head detects the engine coolant temperature and emits signals to the PCM. This part employs a thermistor which is sensitive to changes in temperature. The electric resistance of the thermistor decreases in response to a temperature rise (NTC). The PCM determines engine coolant temperature by the sensor output voltage and provides optimum fuel enrichment when the engine is cold.

Circuit Diagram:

Factory service manual diagram





SENSOR CHECKING USING HI-SCAN PRO

Using Hi-Scan Pro:

Factory service manual diagram





USING MULTI-METER

Factory service manual diagram



1. Remove the engine coolant temperature sensor from the intake manifold.
2. With the temperature sensing portion of the engine coolant temperature sensor immersed in hot engine coolant, check the resistance.

Harness Inspection 1:

Factory service manual diagram



3. If the resistance deviates from the standard value greatly, replace the sensor.

Harness Inspection 1:

Factory service manual diagram



Harness Inspection 2:

Factory service manual diagram





Troubleshooting Procedures:

Factory service manual diagram





Using Voltmeter:

Factory service manual diagram





TROUBLESHOOTING HINTS
If the fast idle speed is not adequate or the engine gives off dark smoke during warm-up, the engine coolant temperature sensor might be the cause.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.