Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL
1. Drain the coolant to a level below the bottom of the sensor.
2. Disconnect the ground cable from the battery and then remove the sensor connector.

3. Remove the coolant sensor.
INSTALLATION
1. Tighten the coolant temperature sensor to the specified torque after applying the sealant to the screw area.
Recommended sealant: Threebond No. 1324N or LOCTITE 262
Tightening torque
The coolant temperature sensor: 20 - 40 Nm (200 - 400 kg.cm, 14 - 29 ft. lbs.)
2. Connect the sensor to the harness.
3. Connect the ground cable to the battery.
4. Refill the engine coolant.
1. Drain the coolant to a level below the bottom of the sensor.
2. Disconnect the ground cable from the battery and then remove the sensor connector.
3. Remove the coolant sensor.
INSTALLATION
1. Tighten the coolant temperature sensor to the specified torque after applying the sealant to the screw area.
Recommended sealant: Threebond No. 1324N or LOCTITE 262
Tightening torque
The coolant temperature sensor: 20 - 40 Nm (200 - 400 kg.cm, 14 - 29 ft. lbs.)
2. Connect the sensor to the harness.
3. Connect the ground cable to the battery.
4. Refill the engine coolant.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
