Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE
Steering Angle
CHECKING STEERING ANGLE

1. Place the front wheel on a turning radius gauge and measure the steering angle.
Wheel angle [Standard value]
Inside wheel: 35.1° ± 1°30'
Outside wheel: 30.7°
2. If the measured value is not within the standard value, adjust the toe and inspect again.
NOTE:
1. After adjusting the tie rod, assemble the bellows so they are not twisted.
2. The inner steering angle is changed 0.86° per each rotation of the tie rod.
1. Place the front wheel on a turning radius gauge and measure the steering angle.
Wheel angle [Standard value]
Inside wheel: 35.1° ± 1°30'
Outside wheel: 30.7°
2. If the measured value is not within the standard value, adjust the toe and inspect again.
NOTE:
1. After adjusting the tie rod, assemble the bellows so they are not twisted.
2. The inner steering angle is changed 0.86° per each rotation of the tie rod.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
