2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE

Rear Wheel Alignment

REAR WHEEL ALIGNMENT

TOE-IN
Standard value: 0 ± 2 mm (0 ± 0.08 inch)

NOTE:
1. The rear suspension lower arm mounting cam bolt should be turned an equal amount on both sides during adjustment.

Right wheel: Clockwise direction: toe-out
Left wheel: Clockwise direction: toe-in

Factory service manual diagram




2. The cam bolt should be adjusted within a 90° range left and right from the center position.

CAMBER
Standard value: 0°30' ± 30'

NOTE:
1. The rear suspension upper arm mounting cam bolt should be turned an equal amount on both sides during adjustment.
2. Install the left and right springs using the same ID color.

Factory service manual diagram




3. The cam bolt should be adjusted within a 90° range left and right from the center position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.