2001 Hyundai Santa Fe L4-2.4LFACTORY OEM SERVICE PROCEDURE

Body Control Module: Description and Operation

Circuit Description
The ETACS control module (Electronic Time and Alarm Control system control Module) controls the front wiper & washer, chime bell, keyless entry & burglar alarm, power door lock, courtesy and tail gate lamps, rear window defogger & outside mirror defogger, room lamp delay, door warning, seat belt warning, ignition key hole illumination and door key hole illumination.

The module receives battery voltage at all times from fuse 11. Fuse 9/fuse 19 supply battery voltage to the module when the ignition switch is in the ON or START position. For details on the use of the various inputs and outputs, see the system indicated in the schematic diagram.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.