Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Control Module: Locations
M29 Starter clutch pedal position switch, M30 Cruise clutch pedal position switch:
E59-1,E59-2 Transaxle control module (TCM):
M29 Starter clutch pedal position switch, M30 Cruise clutch pedal position switch:
M35:
MI01,MI02,MI03,MI04:
MM02:
E59-1,E59-2 TCM:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.