Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Hyundai Tiburon AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Module | In right side of trunk, behind trim. |
| A/T Shift & Key Lock Control Module | Behind left side of dash, above kick panel. |
| Cruise Control Module | Below center of dash, in front of console. |
| DRL Control Module | In left front corner of engine compartment, near battery. |
| Electronic Power Steering Control Module (EPSCM) | On left side of luggage compartment. |
| Electronic Time & Alarm Control Module (ETACM) | Below center of dash, in front of console. |
| Engine Control Module (ECM) | Behind left side of dash. See Figure . |
| SRS Control Module (Air Bag) | Below rear of center console. |
| Transaxle Control Module (TCM) | Behind left side of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.