Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Hyundai Tiburon AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES
| Component | Component Location |
|---|---|
| Dash Fuse Box | Below left side of dash, at kick panel. |
| Diode (Z08) | Taped inside control wire harness, above left kick panel. |
| Diodes (Z01, Z02, Z09 & Z12) | Taped inside main wire harness, near dash fuse box. |
| Diodes (Z05, Z06, Z07 & Z10) | Taped inside engine wire harness, near TCM. |
| Engine Compartment Relay & Fuse Box | Left side of engine compartment, in front of shock tower. See Figure . |
| Fusible Links (A Through K) | In engine compartment relay & fuse box. |
| Passenger Compartment Relay Box | Behind left side of dash, left of steering column. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.