Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Hyundai Tiburon AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Drive Belt Adjusting Bolt/Nut | |||
| Except Sonata | 9-11 (12-15) | ||
| Sonata | |||
| 4-Cylinder | 15-19 (20-25) | ||
| V6 (Adjuster Pulley Nut) | 14-20 (20-27) | ||
| Generator Mounting Bolt | |||
| Lower | |||
| Accent | 14-18 (19-24) | ||
| Sonata 4-Cylinder | 26-41 (34-54) | ||
| All Other Models | 15-19 (20-25) | ||
| Upper (Sonata V6 Only) | 9-11 (12-15) | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.