Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON L4-1.8LREPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONTIMER/CONTROL UNITSERVICE AND REPAIR
1998 Hyundai Tiburon L4-1.8L
Timer/Control Unit: Service and Repair
1998 Hyundai Tiburon L4-1.8LSECTION Service and Repair
1. Disconnect the battery negative terminal.
2. Remove the shift lever boot using a (-) driver.
3. Remove the center facia panel.
4. After removal of ETACM (Electronic Time and Alarm Control Module) mounting bolts (2EA), disconnect its connector.
5. Installation is the reverse order of removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.