Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON L4-1.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSALIGNMENTREAR WHEEL ALIGNMENT SPECIFICATIONS
1998 Hyundai Tiburon L4-1.8L
Rear Wheel Alignment Specifications
1998 Hyundai Tiburon L4-1.8LSECTION Rear Wheel Alignment Specifications
GENERAL SPECIFICATIONS
Toe-In 7 mm - 3 mm (0.28 inch - 0.12 inch)
Camber -54' ± 30'
Rear Wheel Alignment Inspection (Standard Value): 7-3 mm (0.28-0.12 inch)
Toe-In 7 mm - 3 mm (0.28 inch - 0.12 inch)
Camber -54' ± 30'
Rear Wheel Alignment Inspection (Standard Value): 7-3 mm (0.28-0.12 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.