Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON L4-1.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSPECIFICATIONSELECTRICAL SPECIFICATIONS
1998 Hyundai Tiburon L4-1.8L
Electrical Specifications
1998 Hyundai Tiburon L4-1.8LSECTION Electrical Specifications
| Sensor Type | Variable Resistor | |
| Resistance Measured Between Terminal 2 And 3 | Sensor Range | 0.7-3.4 |
| Standard Value | 0.7-3.0 | |
| With Engine Idling | 2.3-3.4 | |
| Measured Output Voltage Throttle position sensor output voltage (TP sensor side connector No.1 or ECM harness side connector No.73) | At Idle (800 RPM) | 0.1-0.875 |
| Wide Open Throttle | 4.25-4.8 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.