Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON L4-1.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSPECIFICATIONS
1998 Hyundai Tiburon L4-1.8L
Air Flow Meter/Sensor: Specifications
1998 Hyundai Tiburon L4-1.8LSECTION Specifications
With engine warmed up between 176 to 198 degrees farenheit
| Sensor Type | Hot Film |
| Output Voltage Range | 0-5 Volts (V) |
| Measured Output Voltage mass air flow sensor output voltage (MAF sensor side connector No. 1 or ECM harness side connector No. 41) | Idle (800 RPM) 0.7-1.1 Volts (V) |
| 3000 RPM 1.3-2.0 Volts (V) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.