Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON L4-1.8LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSPECIFICATIONSFRONT WHEEL ALIGNMENT SPECIFICATIONS
1998 Hyundai Tiburon L4-1.8L
Front Wheel Alignment Specifications
1998 Hyundai Tiburon L4-1.8LSECTION Front Wheel Alignment Specifications
GENERAL SPECIFICATIONS
Toe-In 3 mm in to 3 mm out (0.12 inch in to 12 inch out)
Camber -10' ± 30'
Caster 2°27' ± 30'
King Pin Inclination Angle 12°43' ± 30'
King Pin Offset -1.2 mm
Steering Angle:
Inner Wheel 35°37' ± 1°30'
Outer Wheel 30°76'
Toe-In 3 mm in to 3 mm out (0.12 inch in to 12 inch out)
Camber -10' ± 30'
Caster 2°27' ± 30'
King Pin Inclination Angle 12°43' ± 30'
King Pin Offset -1.2 mm
Steering Angle:
Inner Wheel 35°37' ± 1°30'
Outer Wheel 30°76'
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.