Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Hyundai Tiburon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Retrieving Codes
NOTE:
For specific scan tool operating procedures, see the scan tool manufacturer's instruction manual.
- Before entering on-board diagnostics, refer to SERVICE PRECAUTIONS. Turn ignition off. Locate Data Link Connector (DLC). Connect scan tool. See Fig 1 .
- Operate scan tool according to manufacturer's instructions. Read and record scan tool self-diagnostic output. Perform necessary repair(s). See DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS and appropriate DIAGNOSTIC TESTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.