Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Hyundai Excel GL, StandardFACTORY OEM SERVICE PROCEDURE
MPI Control Relay (Sonata V6)
- Remove control relay, located under right side of dashboard, near blower motor housing. Apply battery voltage across terminals No. 6 (positive) and No. 8 (negative) while checking voltage on terminals No. 1 and 2. See Fig 1 . Replace relay if battery voltage does not exist.
- Apply battery voltage across terminals No. 7 (positive) and No. 10 (negative) while checking continuity between terminals No. 3 and 4. Replace relay if continuity does not exist.
- Apply battery voltage across terminals No. 3 (positive) and No. 9 (negative) while checking voltage on terminal No. 4. Replace relay if battery voltage does not exist.
- Disconnect ECM connector. Turn ignition on. Using DVOM, measure voltage between ECM harness connector terminal No. 6 (10-pin connector) and vehicle ground. If voltage is less than battery voltage, inspect and repair circuit as needed.
- Disconnect control relay harness connector. Using DVOM, measure voltage between control relay harness connector terminal No. 6 (White/Blue wire) and vehicle ground. If voltage is less than battery voltage, inspect and repair circuit as needed.
- Turn ignition off. Using ohmmeter, check resistance between control relay harness connector terminal No. 8 (Black) and ECM harness connector terminals No. 16 and 17 (18-pin connector). See Figure . If continuity does not exist, inspect and repair circuits as needed.
- Using ohmmeter, check resistance between control relay harness connector terminal No. 1 (Black/Red wire) and ECM harness connector terminals No. 4 and 9 (18-pin connector). See Figure . If continuity does not exist, inspect and repair circuits as needed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
