Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Hyundai Excel Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
ISC Motor (1.5L & 2.4L)
- Disconnect ISC motor connector. Check motor coil continuity between terminals No. 1 and 2. See Figure . Resistance should be 5-35 ohms. If resistance is zero ohms or far more than specification, an open or short exists in motor coil. Replace ISC servo assembly.
- Connect 6 volts DC (four 1.5-volt DC batteries) between terminals No. 1 and 4 of ISC motor connector to operate ISC motor. DO NOT apply more than 6 volts. If motor does not operate, replace ISC motor assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.