Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Hyundai Excel GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Valve Clearance: Excel
- Ensure head bolts are properly tightened before adjusting valves. Ensure engine is at normal operating temperature. Rotate crankshaft clockwise to position cylinder No. 1 on TDC of compression stroke.
- Adjust intake valves on cylinders No. 1 and 2, and exhaust valves on cylinders No. 1 and 3. Rotate crankshaft clockwise 360 degrees to position cylinders No. 4 on TDC of compression stroke.
- Adjust intake valves on cylinders No. 3 and 4, and exhaust valves on cylinders No. 2 and 4. See VALVE CLEARANCE SPECIFICATIONSΒ table.
VALVE CLEARANCE SPECIFICATIONS (1)
| Application | In. (mm) | |||
|---|---|---|---|---|
| Hot Engine | ||||
| Intake | .006 (.15) | |||
| Exhaust | .010 (.25) | |||
| Cold Engine | ||||
| Intake | .003 (.07) | |||
| Exhaust | .007 (.17) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
