Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Circuits
With ignition off. Disconnect Electronic Control Unit (ECU) connector(s). Use a DVOM to probe ECU terminal connector. Check that battery (back-up power) voltage is present at ECU terminal A3 (White/Blue wire). Turn ignition on and ensure battery voltage is present at terminals A4 and A9 (Red wire). See appropriate wiring diagram in WIRING DIAGRAMS article. Repair circuits as required.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.