Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Position Sensor (TPS)
Disconnect TPS connector at carburetor. Check resistance using an ohmmeter between terminals No. 2 and 3. See Figure . Ensure that when throttle valve is slowly operated from closed to wide open throttle position, resistance changes smoothly. If resistance is not smooth, replace TPS.
| Throttle Position | Ohms |
|---|---|
| Closed | 1,200 |
| Wide Open | 4,900 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
