Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 3 (Lighting System)
WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B0525
- DTC B0527, B0528, or B0529
- DTC B0530
- DTC B0532, B0533, or B0534
- DTC B2532 or B2533
- DTC B2557 or B2558
- DTC B2562 or B2563
- DTC B2575
- DTC B2582 or B2583
- DTC B2585
- DTC B2602 or B2603
- DTC B2622 or B2623
- DTC B2647 or B2648
- Symptoms - Lighting
- Backup Lamps Malfunction (Automatic Transmission)
- Backup Lamps Malfunction (Manual Transmission)
- Cargo Lamps Malfunction
- Courtesy Lamps Malfunction
- Daytime Running Lamps Malfunction
- Front Fog Lamps Malfunction
- Hazard Lamps Malfunction
- Headlamps Malfunction
- Interior Backlighting Malfunction
- Park, License, and/or Tail Lamps Malfunction
- Stop Lamps Malfunction
- Turn Signal Lamps and/or Indicators Malfunction
- Repair Instructions
- Stop Lamp Switch Adjustment
- Stop Lamp Switch Replacement
- Headlamp Switch Replacement
- Trailer Lamp Control Module Replacement
- Door Jamb Switch Replacement
- Hazard Warning Switch Replacement
- Ambient Light Sensor Replacement
- Dome Lamp Replacement
- Dome Lamp Bulb Replacement
- Headlamp Replacement
- Headlamp Bulb Replacement
- Headlamp Aiming
- Front Fog Lamp Replacement (Canyon)
- Front Fog Lamp Replacement (Colorado)
- Front Fog Lamp Bulb Replacement (Canyon)
- Front Fog Lamp Bulb Replacement (Colorado)
- Fog Lamp Aiming (Canyon)
- Fog Lamp Aiming (Colorado)
- Park/Turn Signal/Side Marker Lamp Bulb Replacement
- High Mount Stop Lamp Replacement
- High Mount Stop Lamp Bulb Replacement
- Backup Lamp Bulb Replacement
- Rear License Plate Lamp Bulb Replacement
- Tail Lamp Replacement
- Tail Lamp Bulb Replacement
- Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
