Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Hummer H3 L5-3.7LFACTORY OEM SERVICE PROCEDURE
Generator Bracket Replacement
Generator Bracket Replacement (LLR) (3.7L)
Removal Procedure
1. Remove the generator. Refer to Generator Replacement (LLR) (Generator Replacement)Generator Replacement (LH8) (Generator Replacement).
2. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement (Service and Repair).
3. Remove the engine wiring harness bracket bolt (4).
4. Reposition the engine wiring harness bracket out of the way.
5. Disconnect the power steering gear inlet and outlet hose.Refer to Power Steering Gear Inlet and Outlet Hose Replacement (LLR) (Service and Repair)Power Steering Gear Inlet and Outlet Hose Replacement (LH8) (Service and Repair)
6. Remove the generator bracket bolts.
7. Remove the generator bracket,with the power steering pump attached,from the vehicle.
8. Transfer power steering pump.Refer to Power Steering Pump Replacement (LH8) (Power Steering Pump Replacement)Power Steering Pump Replacement (LLR) (Power Steering Pump Replacement)
Installation Procedure
1. Position the generator bracket in the vehicle.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the generator bracket bolts.
Tighten the bolts to 50 Nm (37 lb ft).
3. Position the engine wiring harness bracket to the generator bracket.
4. Install the engine wiring harness bracket bolt (4).
Tighten the bolt to 40 Nm (29.5 lb ft).
5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement (Service and Repair).
6. Install the generator. Refer to Generator Replacement (LLR) (Generator Replacement)Generator Replacement (LH8) (Generator Replacement).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
