Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Without Scan Tool-Learn
- The engine speed is between 450-4,000 RPM.
- The manifold absolute pressure (MAP) is greater than 5 kPa.
- The mass air flow (MAF) is greater than 2 g/s.
- The ignition 1 voltage is greater than 10 volts.
- Start and idle the engine in Park for 3 minutes.
- With a scan tool, monitor desired and actual RPM.
- The ECM will start to learn the new idle cells and Desired RPM should start to decrease.
- Ignition OFF for 60 seconds.
- Start and idle the engine in Park for 3 minutes.
- After the 3 minute run time the engine should be idling normal.
- If the engine idle speed has not been learned the vehicle will need to be driven at speeds above 70 km/h (44 mph) with several decelerations and extended idles.
- After the drive cycle, the engine should be idling normally.
- If the engine idle speed has not been learned, turn OFF the ignition for 60 seconds and repeat step 6.
- Once the engine speed has returned to normal, clear DTCs.
IMPORTANT:
Do NOT perform the Without Scan Tool-Learn procedure if DTCs are set. Refer to Diagnostic Trouble Code (DTC) List - Vehicle
.
IMPORTANT:
During the drive cycle the check engine light may come on with idle speed DTCs. If idle speed codes are set, clear codes so the ECM can continue to learn.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
