2009 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Of Fuel Rail Assembly With Injectors
    GM1565311Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly ReplacementΒ .
  2. Disconnect the fuel injector harness electrical connector from the fuel injector.
  3. Remove and discard the fuel injector retainer clip.
  4. Pull the fuel injector from the fuel rail.
  5. Fig 2: View Of Fuel Injector, Clip & O-Rings
    GM351185Courtesy of GENERAL MOTORS CORP.
  6. Remove and discard the fuel injector O-ring seals (2, 4) from both ends of the fuel injector (3).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.