2009 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Front View Camera Switch Replacement (H3T)

Fig 1: Front View Camera Switch Replacement (H3T)
GM2178115Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the center instrument panel (I/P) trim panel. Refer to Instrument Panel Center Trim Panel Replacement (Right Hand Drive) or Instrument Panel Center Trim Panel Replacement (Left Hand Drive) .
1 Front View Camera Switch

Procedure

  1. Disconnect electrical connector.
  2. Depress tabs and unsnap switch from Bezel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.