2009 Hummer H3 AlphaFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor Replacement

Fig 1: Camshaft Position Sensor Replacement
GM2003676Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Camshaft Position Sensor Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Procedure:Β 
Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.

Tighten:Β  12 N.m (106 lb in)

2 Camshaft Position Sensor Bracket Assembly
Procedure:Β 
Disconnect the electrical connectors.
3 Camshaft Position Sensor
4 Camshaft Position Sensor O-ring Seal
Procedure:Β 
Lubricate the O-ring seal with clean engine oil.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.