2009 Hummer H2 V8-6.2LFACTORY OEM SERVICE PROCEDURE

Door Component Views




Door Component Views

Front Doors

Factory service manual diagram



1 - Door Courtesy Lamp-Driver
2 - Outside Rearview Mirror-Driver
3 - Memory/Heated Seat Switch-Driver
4 - Door Lock/Window Switch-Driver
5 - Speaker-Left Front
6 - Speaker-Right Front
7 - Door Lock/Window Switch-Passenger
8 - Heated Seat Switch-Passenger
9 - Outside Rearview Mirror-Passenger
10 - Door Courtesy Lamp-Passenger
11 - Door Latch -Passenger
12 - Inflatable Restraint Side Impact Sensor (SIS) - Right Front
13 - Window Motor-Passenger
14 - Window Motor-Driver
15 - Inflatable Restraint Side Impact Sensor (SIS) - Left Front
16 - Door Latch -Driver

Rear Passenger Doors

Factory service manual diagram



1 - Door Courtesy Lamp-Left Rear
2 - Window Switch-Left Rear
3 - Speaker-Left Rear
4 - Speaker-Right Rear
5 - Window Switch-Left Rear
6 - Door Courtesy Lamp-Right Rear
7 - Door Latch Right Rear
8 - Inflatable Restraint Side Impact Sensor (SIS) - Right Rear
9 - Window Motor-Right Rear
10 - Window Motor-Left Rear
11 - Inflatable Restraint Side Impact Sensor (SIS) - Left Rear
12 - Door Latch -Left Rear

Liftgate

Factory service manual diagram



1 - Center High Mounted Stop Lamp (CHMSL) Connector
2 - Rear Window Defogger Grid Connector
3 - Rear Window Defogger Grid Connector
4 - Splice J900
5 - Rear Window Wiper Motor (C25)
6 - Door Lock Actuator - Liftgate
7 - Liftgate Ajar Switch - Left
8 - Liftgate Ajar Switch - Right
9 - Splice J902
10 - Splice J901

Liftgate

Factory service manual diagram



1 - Center High Mounted Stop Lamp (CHMSL) Connector
2 - Rear Window Defogger Grid Connector
3 - Rear Window Defogger Grid Connector
4 - Splice J900
5 - Rear Window Wiper Motor (C25)
6 - Door Lock Actuator - Liftgate
7 - Liftgate Ajar Switch - Left
8 - Liftgate Ajar Switch - Right
9 - Splice J902
10 - Splice J901
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.