Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| Fuel Tank Filler Ground | Left rear frame body mount. See Figure. |
| G100 (5) | On left front frame body mount. See Figure. |
| G101 (6) | Right front corner of vehicle on frame rail near front tow hook. See Figure. |
| G102 (3) | Left front side of engine block. See Figure. |
| G103 (4) | On front of right cylinder head. See Figure. |
| G104 (5) | At rear of left cylinder head. See Figure. |
| G106 | On rear of engine compartment, near left cylinder head. See Figure. |
| G200 | On left side of dash, behind left kick panel. See Figure. |
| G203 | Lower right side of dash, behind right kick panel. |
| G300 | On left side body mount, in front of driver door. See Figure. |
| G301 (9) | Under passenger seat, near X305. See Figure. |
| G302 | In left "B" pillar behind trim panel. See Figure. |
| G304 (8) | On right side middle body mount, near second row seating area. See Figure. |
| G306 | In right "B" pillar, behind trim panel. See Figure. |
| G401 | Left rear frame body mount. See Figure. |
| G402 | Attached to front of air suspension mounting bracket. |
| G403 (3) | Left rear of passenger compartment, near midgate behind trim panel. See Figure. |
| G405 (11) | At right rear frame body mount. See Figure. |
| G410 (3) | On passenger side rear of body, near "D" pillar behind trim panel. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
