2008 Hummer H3 Base, StandardFACTORY OEM SERVICE PROCEDURE

Component Resistance

Component Pass Through Pins Resistance 25°C (77°F) Resistance 150°C (302°F) Resistance to Ground (Case)
Vehicle Speed Sensor 1, 2 1,300-1,500 Ω 2,360-3,160 Ω Greater than 10 M Ω
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.